Gun Mounts

Additional base plates are great for allowing you to move your compact floor mount from vehicle to vehicle.  Measures 6" x 6"...

If your gun holder is constantly exposed to sun, rain, or mud etc. or commercial use (e.g. hunting preserves).  Rugged Gear recommends replacing Hooks or VELCRO® Brand fastener on an annual basis or sooner, if upon inspection of the Hook and loop fastener it is showing si..

Just like our standard base plate, with the added improvement of galvanizing hot dipped plating.  There are instances where the storage or use environment of your Rugged Gear floor mount has a higher added risk of potential corrosion.  Premature failure due to rusting can be signif..

Easily and quickly mounts to ATV racks, including most composite racks, or to any round or square bar, or handlebars.Can be adjusted to non-parallel positions for use on the front or back of ATV.  Set screw prevents unwanted movement of holder on round bars.  The most "adjustable" holder a..

Semi-permanent Dual Lock mounting system is a strong and continuous-holding removable mount -- yet it eliminates the need for screws or bolts or permanently altering your vehicle. 250 mushroom-shaped stems per inch snap into place for incredible holding power not affected by heat, cold, moisture..

Do you own an expensive shotgun or rifle that requires the utmost in protection for its stock and metal finishes? Then consider Rugged Gear's new Fine Gun Holder Covers with the following features and benefits:Made from extremely soft cream-colored polyester with Sherpa Faux backing..

Do you own an expensive shotgun or rifle that requires the utmost in protection for its stock and metal finishes? Then consider Rugged Gear's new Fine Gun Holder Covers with the following features and benefits:  Made from extremely soft, cream-colored polyester with Sherpa Faux bac..

Thumbscrews.  They are included with the 2 and 4-Gun Removable Floor Mounts and also our 4-Gun Shooting Carts. Our adapter plates also come with thumbscrews. If you need replacements, this is what you need...

Floor Mount Backing Plate Set.  Use for additional support through wood or plastic floors...

For Use with any Floor Mount (Part # 10082, 10083, 10084, 10086, 11072, 11073) in the center cab floor of a John Deere Gator UXV & XUVs. Locate adapter plate over drive shaft tunnel and drill four mounting holes thru steel floor of UTV. Includes mounting hardware and instructions. Picture a..

For use with any Floor Mount (Part # 10082, 10083, 10084, 10086, 11072, 11073) in the center cab floor of a 2008 and up Kawasaki Teryx (will not fit a Teryx4).  Installs over driveshaft cover by removing four nylon rivets and inserting included mounting hardware.  Includes two backing..

Securely holds two bowsAdjustable brackets and hook locations ensure practically every compound bow will fit.Removable Floor Mount (Part # 11072), Base Plate mounts to the floor, holder then easily attaches to and removes from plate with thumbscrews.6" x 6" Base Plate will also accept ou..